G&W Fret Slot Depth Gauge

You never want the slot too shallow, that's for sure Still, most companies cut deep slots to account for leveling, inlays & sanding, different

G&W Fret Slot Depth Gauge You generally only use a table saw to cut fret slots when the fretboard is still flat Then after radiusing you just use a hand fretsaw with a

You never want the slot too shallow, that's for sure Still, most companies cut deep slots to account for leveling, inlays & sanding, different

charlie chance in hell to pay slot IF you are about to take on a refret job of a fretted instrument, you should be checking the depth of the fret slots Still a good idea to check the fret slot

The picture below shows a guitar neck, the fret slots can either be cut at a 3 mm depth following the radius of the fretboard or

fret slot width The picture below shows a guitar neck, the fret slots can either be cut at a 3 mm depth following the radius of the fretboard or

Fretwire has a toothed piece called the tang which will stick into a slot in the fretboard The tang is typically in width, so ideally you